Some 'Move Table to I/O Unit' PAC Control commands don't work as expected with mistic I/O

Applies To:

SNAP-PAC-S1
SNAP-PAC-S2

Versions Affected:

Problem was discovered in version: R8.1a
Problem is fixed in version: R8.2a

Resolved In Version:

Problem is fixed in version: R8.2a

Symptoms:

Various Move Table to I/O Unit commands do not work as expected with mistic I/O units.

Move Table to I/O Unit: Moving a table with less than 32 elements to an analog mistic I/O unit returns error -12.

IVAL Move Numeric Table to I/O Unit: IVALs are not written to mistic analog and digital input points. Additionally, moving a table with less than 32 elements to an analog I/O unit, returns error -12.

Move Table to I/O Unit Ex: The Points per Module parameter is ignored and the command requires the table length be 8 times that value. Only the first 16 elements of the table are used to write to analog or digital outputs.

IVAL Move Numeric Table to I/O Unit Ex: IVALs are not written to mistic analog or digital input points.

Resolution:

Opto 22 has resolved this issue.

Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com

DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.