KB81707
Published: January 6, 2012
Revision: 1.0

Cannot connect with Listen and Accept Incoming Communication commands


Applies To:

SNAP-PAC-S1
SNAP-PAC-S2
SNAP-PAC-S1-W
SNAP-PAC-S2-W
SNAP-PAC-R1
SNAP-PAC-R2
SNAP-PAC-R1-W
SNAP-PAC-R2-W

Versions Affected:

Problem was discovered in version: R9.1d


Symptoms:

'Error -441, No listening on socket' may be returned when listening for peer communication in a PAC Control strategy. An example of this type of TCP/IP communication is shown in the example on page 255 of the PAC Control User's Guide (form 1700, revision 111014).

The commands Listen for Incoming Communication and Accept Incoming Communication are used to establish the TCP/IP communication. The Accept Incoming Communication command is called repeatedly, with no connection ever established.


Workaround:

If error -441 is returned when the Accept Incoming Communication command is executed, change the strategy to loop back to the block with the Listen for Incoming Communciation command and add a 100 ms delay after the Listen for Incoming Communication command.


Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.