KB83281
Published: October 3, 2013
Revision: 1.0

Cannot communicate over Ethernet after restoring the groov Box


Applies To:

GROOV-AT1

Versions Affected:

Problem was discovered in version: 1.570.23
Problem is fixed in version: 1.570.30

Resolved In Version:

Problem is fixed in version: 1.570.30


Symptoms:

groov cannot communicate over Ethernet after restoring the groov box to defaults. You cannot find the groov box using groov Find.

Workaround:

1. Use groov Find to establish communications with the groov box over ETH0 or ETH1 as follows:

  • Connect ETH0 to a network, with or without a DHCP server available. If there is no DHCP server, wait 60 seconds for a Link-Local IP address to be assigned. Use groov Find to try and find the groov box.
  • Connect ETH1 to a network with a DHCP server available. Use groov Find to try and find the groov box.

2. Do the following only if you are not able to connect to either ETH0 or ETH1 as described in step 1:

Use groov Admin to re-enable the wired Ethernet interfaces. Go to the Network Configuration page and re-configure the Ethernet interface that was unable to communicate. NOTE: groov Admin will not show it as disabled.


Resolution:

Opto 22 has resolved this issue.

Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.