KB85793
Published: April 27, 2016
Revision: 2.0

PAC Display Professional project loads slowly, may show out of memory error; project .UUI file grows to several hundred megabytes


Applies To:

PAC Display Professional

Versions Affected:

Problem was discovered in version: R9.4g and may affect previous versions
Problem is fixed in version: R9.5a

Resolved In Version:

Problem is fixed in version: R9.5a


Symptoms:

The PAC Display project file (file extension .UUI) grows to several hundred megabytes over the course of saving the project. The large file size can cause the project to load very slowly. In addition, you may see a PAC Display popup message showing "Out of memory" or "PAC Project Load Status (Not Responding)."

This issue affects PAC Display Configurator Pro only (not PAC Display Basic).

Resolution:

Opto 22 has resolved this issue.

If this problem affects you, download and install version R9.5a (or higher), open the affected project, and save it. File size should return to normal.

Questions?

Contact: Opto 22 Product Support.
Phone: 800-835-6786 or 951-695-3080
Email: support@opto22.com


DISCLAIMER

This Opto 22 Knowledge Base ('OptoKB') article is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such subjects. Accordingly, the information in this OptoKB article is not intended to constitute application, design, software, or other professional engineering advice or services. Opto 22 may modify the OptoKB articles at any time. Before making any decision or taking any action which might affect your equipment, you should consult a qualified professional.

OPTO 22 DOES NOT WARRANT THE COMPLETENESS, TIMELINESS, OR ACCURACY OF THE DATA CONTAINED IN THIS OPTOKB ARTICLE AND MAY MAKE CHANGES THERETO AT ANY TIME AT ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS 'AS IS.' IN NO EVENT SHALL OPTO 22 BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT, OR DAMAGE, EVEN IF OPTO 22 HAS BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.

OPTO 22 DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED WITH RESPECT TO THE INFORMATION (INCLUDING HARDWARE, SOFTWARE, AND/OR FIRMWARE) PROVIDED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTIBILITY, AND NON-INFRINGEMENT. Note that certain jurisdictions do not sanction the exclusion of implied warranties: thus, this disclaimer may not apply to you.

Copyright © 2024 Opto 22. All rights reserved.