$29.50 (USA and Canada only)
The ODC5R is a Form A mechanical relay I/O module. This module was designed for a low-voltage DC load that that is purely resistive (no inrush current).
Typical applications for these modules include analog signal and communication line multiplexing. Because of their low 10 VA rating, these modules are not recommended for inductive or capacitive loads (even very small loads) because the inrush current is likely to exceed the 10 VA rating.
IMPORTANT: Applications using 120 VAC are typically NOT suited to this module. If you are considering using this module for any application other than low-voltage purely resistive loads, see the detailed notes and rating curve in the data sheet, and call Pre-sales Engineering for specific guidance.
Item
Description
Contact type
Form A SPST-normally open
NOTE: The application of the dry contact module must not exceed 10 VA under steady-state or momentary in-rush conditions.
For voltages at or below 20 volts, the current limit is 0.5 amps. For voltages above 20 volts, the maximum allowable current is determined by the following equation:
Maximum Current = 10 VA / Voltage
Line Voltage - Range
0–100 VDC 0–130 VAC (see Note)
Current Rating
0.5 Amps Switching (see Note)
Contact Rating
10 VA (see Note)
Switching current
0.5 amperes maximum1
Carry current
1.5 amps maximum
Contact on-resistance
200 milliohms
Turn-on time
500 microseconds
Turn-off time
Contact bounce
250 microseconds
Mechanical life
5 x 106 cycles
Logic voltage range
4.8–6 volts
Logic droupout voltage
0.8 volts
Logic input current @ Normal logic voltage
14 milliamperes
Isolation voltage Input-to-output
1500 VDC
Temperature Operating
0 to 70 °C
Current Limit at Key Voltages
V
mA
5
500
12
24
416
1001
100
120
83
1302
76
1. Maximum DC voltage is 100 VDC
2. Maximum AC voltage is 130 VAC
The ODC5R is a Form A mechanical relay I/O module. This module is ideal for applications requiring a dry-contact closure.
This document is the Manufacturer's Declaration of Conformity for the products listed herein, in accordance with the rules, regulations and standards of the United Kingdom. The models cited have been tested to the essential requirements listed in the Standards section, and fully comply with the legislation as listed in UK Legislation section.
This document is the Manufacturer's Declaration of Conformity for the products listed herein, in accordance with European, international, and/or national standards and regulations.
This document is a statement of compliance with the EU Directive 2015/863/EU, Restriction of Hazardous Substances (RoHS 3). This document lists Opto 22 products that comply with the substance restrictions of the RoHS 3 directive.
This document lists all Opto 22 part numbers that have the Underwriters Laboratory (UL) approval.
This document is the Manufacturer's Declaration for the listed products as mentioned in the attachment - to which this confirmation refers - that they are in accordance with the mentioned European, international and/or national standards and regulations.